The most common signs a house needs tuckpointing are recessed or sandy mortar joints, holes and gaps, stair-step cracks, white staining on the brick, and loose or flaking brick. Gateway City Tuckpointing checks for all of these on free estimates across University City and St. Louis, but you can spot most of them yourself in about twenty minutes.
Mortar is designed to be the weak link in a brick wall. It is softer than the brick, it wears first, and it is meant to be replaced every so often so the brick itself lasts for generations. The trouble is that failing mortar is easy to ignore until water is already inside the wall. In St. Louis, where winters swing above and below freezing over and over, that water freezes, expands and pushes the masonry apart a little more every year.
Pick a dry day, grab a house key, a flashlight and your phone camera, and walk all four sides of the house. Look closely at the areas that get the most weather: the chimney, the parapet or top of the wall, under windowsills, around downspouts and along the bottom few courses near the ground.
1. Mortar Joints That Sit Behind the Brick Face
On a healthy wall the mortar sits roughly flush with, or slightly tooled into, the face of the brick. As it erodes, the joints recede and you start to see deep shadows between the bricks.
How to check: Look along the wall at an angle, not straight on. If the joints have receded about a quarter inch or more, the wall is due. That's the point where water starts sitting on the brick edges instead of shedding off.
2. Sandy, Crumbly Mortar
Old lime mortar softens over time, and eventually it turns back into something close to sand.
How to check: Drag the tip of a key along a joint. Sound mortar resists and leaves a faint scratch. Failing mortar scrapes out easily and leaves a little pile of grit on the sill or ground below. If you find this in several places, it's not a spot repair anymore.
3. Holes, Gaps and Open Head Joints
The short vertical joints between bricks, called head joints, often fail first. Small holes become entry points for water, insects and, on older homes, the occasional mouse.
How to check: Shine a flashlight along the wall. Count the open joints you can see in a few square feet. In a basement or attic, look for daylight coming through the masonry.
4. Stair-Step Cracks
A crack that zigzags up through the mortar joints like a staircase means part of the wall has moved. Sometimes it's an old, stable crack. Sometimes it's ongoing settlement, a failing lintel or water damage.
How to check: Photograph the crack with a coin or tape measure for scale, then photograph it again in a few months. A crack that grows, or one wider than a pencil, should be looked at. Cracks that run through the bricks themselves, not just the joints, can point to a bigger issue and may need brick replacement and repair as well as repointing.
5. White Staining on the Brick (Efflorescence)
That chalky white bloom on the face of the brick is efflorescence: salts carried out of the masonry by moving water and left behind when the water evaporates. It isn't damage by itself, but it tells you water is traveling through the wall.
How to check: Note where it shows up. Efflorescence under a gutter, beside a downspout or on a chimney usually points to a specific water source. Brush it off with a dry brush; if it comes back after the next rain, the moisture problem is still there.
6. Spalling, Flaking or Loose Brick
When water soaks into brick and freezes, the face of the brick can pop off in flakes or chunks. That's called spalling. Loose bricks at the top of a chimney or parapet are a related problem: the mortar has failed enough that the bricks are just sitting in place.
How to check: Look for bricks with rough, broken faces or fresh brick chips on the ground. From the ground with binoculars, look for gaps or a ragged outline at the top of the chimney. Don't climb up and push on chimney bricks. If they look loose, call someone with the right equipment. Our chimney repair page covers what that work involves.
7. Damp Spots, Peeling Paint or Musty Smells Inside
Sometimes the first sign is inside the house: plaster bubbling on an exterior wall, paint peeling near a window, or a damp, musty basement corner.
How to check: Match the interior spot to the outside wall behind it. If you find open joints or a downspout dumping water right there, you've probably found the path. Persistent dampness on a basement wall can also mean the foundation mortar has washed out, which is common under older St. Louis homes with stone or brick foundations. See masonry foundation repair.
8. A Chimney That Leans, Leaks or Sheds Mortar
Chimneys take more weather than any other part of the house. They're exposed on all four sides, they heat up and cool down, and their crowns crack.
How to check: Stand across the street and compare the chimney to a vertical line like a door frame or utility pole. Look for missing mortar, a cracked crown, bricks with white staining, or mortar debris in the fireplace or on the roof. A chimney that's visibly leaning may need its top section rebuilt rather than repointed.
9. Old Patches That Don't Match
Gray cement smeared over joints, or patches that are a different color and texture than the rest of the wall, are a sign someone already tried a quick fix. Hard patching mortar on older, softer brick can trap moisture and make the surrounding brick deteriorate faster.
How to check: Look for joints that are wider, smoother or a different color than the original. Check the bricks right next to those patches for spalling. Our post on matching mortar on historic St. Louis brick explains why the mix matters.
Where These Signs Show Up Around St. Louis
The housing stock shapes where problems appear. In University City, where most homes date from the early 1900s through the 1940s, we see worn chimneys, recessed joints on the weather side of the house and washed-out limestone foundations. In the Central West End and across St. Louis City, tall brick walls, parapets and cornices on flats and apartment buildings catch the worst of the runoff. In suburbs like Webster Groves and Maplewood, it's often chimneys, front steps and porches.
What to Do Next
If you've only found one or two failing joints, keep an eye on them and fix the water source, like a clogged gutter. If you're seeing several signs, or any loose brick on a chimney or parapet, get it looked at before winter. Repointing a wall is far simpler than rebuilding one after a few more freeze–thaw seasons. For a sense of timing, read how long tuckpointing lasts.
